Virtualmin could not work out the default IPv4 address for virtual servers on your system. You will need to update either the Network interface for virtual addresses or Default virtual server IP address fields on the module configuration page.
.. your system is not ready for use by Virtualmin.
Active Now Interfaces listed in this table are currently active on the system. In most cases, you should edit them under the Activated at Boot tab.
Select all. | Invert selection. | Add a new interface. Name Type IPv4 address Netmask IPv6 address Status
eth0 Ethernet 1000Mb/s No address configured None fe80::225:10ff:fed2:756a Up eth1 Ethernet 1000Mb/s No address configured None fe80::225:10ff:fed2:756b Up lo Loopback 127.0.0.1 255.0.0.0 ::1 Up
Select all. | Invert selection. | Add a new interface.
Activated at Boot Interfaces listed in this table will be activated when the system boots up, and will generally be active now too.
Select all. | Invert selection. | Add a new interface. | Add a new bonding Interface. | Add a new bridge. | Add a new address range. Name Type IPv4 address Netmask IPv6 address Active
eth0 Ethernet 220.127.116.11 255.255.255.248 Yes eth1 Ethernet From DHCP From DHCP From IPv6 discovery Yes lo Loopback 127.0.0.1 255.0.0.0 Yes