Submitted by hescominsoon on Sat, 03/05/2016 - 18:44 Pro Licensee
I ahve the following allocation from my provider:
IPs: 199.15.253.0/29 199.15.253.1 - Gateway 199.15.253.2 - 199.15.253.6 - Usable IPs 255.255.255.248 - Subnet Mask
I ahve .2 on the mahcine now..when i try to add the other ip addies they do not work...I am not figuring out which subnet mask to use with the additional ip's in the range.
Status:
Active
Comments
Submitted by JamieCameron on Sat, 03/05/2016 - 19:05 Comment #1
Can you explain further why the IPs cannot be used? If you create a new domain using the .3 IP, what happens?
Submitted by hescominsoon on Sat, 03/05/2016 - 20:47 Pro Licensee Comment #2
I ahve to add the .3 to the ma hine first it is not there yet...if i add it and then put a domain on it traffic dies. for each individual additional ip do i use the 255.255.255.255 subnet?
Submitted by JamieCameron on Sun, 03/06/2016 - 11:55 Comment #3
Sorry, I don't quite understand what goes wrong when you use the .3 address for a new domain. Does this break network access to your system completely?
Submitted by hescominsoon on Sun, 03/06/2016 - 16:29 Pro Licensee Comment #4
no any domain that gets put onto the additional ip goes nowhere.
it comes down to this. how what netmask should i use for .3 when i enter it into the webmin networking additional ip interface? I do not get the option to add in the gatway and i am not sure the broadcast is going correct either.
Submitted by JamieCameron on Sun, 03/06/2016 - 16:40 Comment #5
You should use the same netmask that you used for your primary IP, which is 255.255.255.248