Submitted by hescominsoon on Sat, 02/25/2017 - 08:29Pro LicenseeComment #2
ok this counts as another bug. I had to add the ipv6 shared address back to the networking interface..then refresh the shared ip address information int he virt section..then i went and removed the ipv6 information from the webmin network interface section..and then it was finally gone from the virt addressing area.
I am really curious why i am hitting so many of these remove-install-remove loops inside of virt? I am assuming this is NOT how it is supposed to work?
Submitted by hescominsoon on Sat, 02/25/2017 - 17:40Pro LicenseeComment #4
i used virt/webmin to remove the ipv6 addresses from the interface. I then had to do the install-remove loop again to get it cleared out completely. I do not feel i should have to look at the config files as virt is supposed to take care of this itself...right?
Comments
Submitted by hescominsoon on Sat, 02/25/2017 - 08:21 Pro Licensee Comment #1
Default IPv6 address for virtual servers is 2604:4100:2:7:223:8bff:fe41:a337.
where do i remove this at?
Submitted by hescominsoon on Sat, 02/25/2017 - 08:29 Pro Licensee Comment #2
ok this counts as another bug. I had to add the ipv6 shared address back to the networking interface..then refresh the shared ip address information int he virt section..then i went and removed the ipv6 information from the webmin network interface section..and then it was finally gone from the virt addressing area.
I am really curious why i am hitting so many of these remove-install-remove loops inside of virt? I am assuming this is NOT how it is supposed to work?
Submitted by JamieCameron on Sat, 02/25/2017 - 16:00 Comment #3
Was the IPv6 address removed from both the active interface, and any config files like
/etc/sysconfig/network-scripts/ifcfg-eth0
?Submitted by hescominsoon on Sat, 02/25/2017 - 17:40 Pro Licensee Comment #4
i used virt/webmin to remove the ipv6 addresses from the interface. I then had to do the install-remove loop again to get it cleared out completely. I do not feel i should have to look at the config files as virt is supposed to take care of this itself...right?
Submitted by hescominsoon on Sat, 04/15/2017 - 18:03 Pro Licensee Comment #5
Submitted by IssueBot on Thu, 10/11/2018 - 20:07 Comment #6
Automatically closed - issue fixed for 2 weeks with no activity.