Submitted by yngens on Wed, 12/16/2015 - 01:28
As shown in the attached picture on "Restore Virtual Servers" page there are two sets of "Select all. | Invert selection." options and unfortunately both of them work for the "Features to restore", but none does for the "Virtualmin settings to restore" section.
Status:
Active
Comments
Submitted by JamieCameron on Wed, 12/16/2015 - 21:17 Comment #1
That's expected though - they apply only to the features list.
Submitted by yngens on Thu, 12/17/2015 - 20:00 Comment #2
That's expected though - they apply only to the features list.I see now, but still their placement is bit confusing IMHO - they usually put another toggle option if the page is too long and after scrolling down the first one is not seen. In this case we have perfectly fit to one screen set of options and two toggle options for one block and at the same time another block just down below the first one without any toggle options.
Not so big deal as I am just throwing all the UI improvement ideas which I encounter on my everyday Virtualmin admin life.
Submitted by JamieCameron on Thu, 12/17/2015 - 22:53 Comment #3
Yes, it is a bit confusing - however, it is consistent with other Virtualmin UI elements, in which the select all / invert selection links appear above and below the list of checkboxes.